Sign in to follow this  
timothy_kaim

Stellar swingarm 660

1 post in this topic

Hello I just purchased a stellar swingarm and I'm having a bit of trouble with installing the bearings the manual is a bit difficult for me to understand. I got the left side in but on the right from the inside by the motor out I have seal,bushing,bearing then theirs a gap then seal washer then end cap and when I put the pivot bushing through its about a half inch long?I measured the old swingarm and the tube on the swingarm measures 3 1/2" and the stellar measures 3"?any help would be greatly appreciated!!53ef02fcb0258608a1cda8c8a6b53ffd.jpgbee4bdd3e5ed698bccf87dbbb2fc8fde.jpg5aca5bc8e60fdade26e79981607e6032.jpg<br />

<br />

Sent from my SM-N920T using Tapatalk

Sent from my SM-N920T using Tapatalk

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this